We continue with the renovation of the old house. I plan on selling this 1920 home once I’ve made a few improvements. The plan is to sell it this year – as a slow and steady worker – this may be a challenge.
Since I replaced the original window over the sink, it’s time to make some new jambs and casings. I usually start with the side jambs. They are ripped to the required width and then cut to length. A little mock-up of the sill is made to get the measurements.
A sill is cut and put into place to allow for measuring the casings.
The side casings are put into place temporarily and a block of wood is used to set the reveal offset. This will allow the top casing to be marked for proper width.
The header is cut to width and the two side casings are attached to the top using kreg screws in the back.
The completed ‘U’ shaped casing is then attached to the window jambs and the wall. I always make casings this way as they will allow for nice tight joints at the corners that won’t open over time.
There was an issue with the soffit nailer at the ceiling. It was 2X2 lumber and well attached to the ceiling lath. I was afraid that if I tried to remove it I would cause quite a bit of plaster damage. So to make lemonade out of lemons, I decided to make a small drop and make it into a design element. I have a 1X7 fascia plate attached to the face of the nailer.
Face nailers were added to allow for the 3/4″ tongue and groove paneling to be added to the ceiling portion.
I am using recycled pine that was originally used on the porch ceiling at my other renovation. It needed a good scuff sanding to get the best paint adhesion.
The T&G paneling is attached to the 3/4″ wall sheathing, butting up with the new window casing.
I brought the T&G siding up onto the ceiling drop and placed a new ceiling light box in the center. I had one long piece of crown molding left from my kitchen renovation in the other house, so I thought this would work well here.
Now we turn our attention to the plumbing – a little copper pipe re-routing and a little fiddling and we can start thinking about new cabinets.
An unfinished base cabinet from Home Depot is reworked to accept the new plumbing.
Holes cut and then I decided adding a Dishwasher might be a good idea. Another electrical box is added for the DW service.
So this is were we are. A dishwasher, and a couple of ready-made base cabinets. Looks like there’s a lot more to do. I see some custom cabinets in my future.
Time to dust off the tools again.