OK, my last post was my thumb with a smiley face on it – right. Not particularly relevant to this renovation blog – except to celebrate that I have been able to keep all my fingers and both thumbs while using power saws and nail guns. So let’s hope my good fortune continues into 2017.
I have yet to get the plumber over to get my fireplace installed – no roaring fire yet. So let’s hop over to the next room and get that TV lift cabinet sorted out. That’s the lift mechanism in that dusty box on the floor – it’s been there for three years – that’s why it’s dusty.
Let’s go over why this thing looks like this. This is used to house a retractable 55″ TV and there is also a cold air return built into this cabinet. The two rectangle boxes actually go through the floor and are connected to the return air plenum for the HVAC. The air returns from the top of the cabinet behind a false wall and the back plywood panel. It’s pretty convoluted, but the calculations for air flow are pretty good. Now the return air vent is on top of the cabinet and out of sight and the room can breathe – so it’s a win-win.
We’ll start by making the face frame and doors out of poplar since this will be painted. The frame is cut and joined with kreg screws. The doors will be routed and have a panel. Here is the first door test fit. These are inset doors, so the fit is more critical than an overlay door.
Having the door opening with no stile allows full access to the TV lift. I ran the speaker wires and communication cables to the cabinet, but decided to put the AV Receiver in the finished crawl space below this cabinet. So only a couple wires will enter this cabinet.
I also painted the inside of the cabinet to make cleaning easier. The wires on the left go through a chase to the top of the bookcase. They might come in handy in the future for something – at least it will be there if I need it. The blue switch box and metal receptacle box on the right are for powering the lift and for a switch for the library lights over the windows in the bookcase..
The doors are drilled for the euro style hinge. These are self-closing hinges from Blum. These are clip top, which allows you to remove and install the doors easily. They also have a three way adjustment that is important – especially on inset doors.
I was thinking the TV lift was going to be complicated, but it’s pretty straightforward. I mounted the lift onto a 1/2″ ply backing board with carriage bolts. I then screwed the board to the back panel. This will make installing and removing the lift a lot easier, as the lift mounting bolt location is too low to get to easily.
So here’s where I am as of yesterday. I’m thinking of a thick walnut or contrasting wood top – the center of which hinges open for the TV. There will be a piece of art hanging behind the lift, so when not in use I can look at something prettier than a black rectangle. That’s the plan – we’ll see if I measured this funky cabinet right, or did I miss something? Time will tell.
More to come – stick around.