6th and Final Mudroom Build…for now.

I know those that follow this little diddy might think that I pooped out on this little renovation project. Au contraire my friends. I’ve been working like a maniac to get some things buttoned up for the winter. You’ll see in some of the following posts. One thing I have yet to do is rent the 24′ box truck to drive up to Shoals Indiana and pick up 10,000 pounds of Indiana limestone to jazz up a couple of walls on this place. I didn’t tell you that? Oh, I’m stripping all of the aluminum siding off the house and putting up cement siding and limestone. Crazy? You bet. Why, here’s a little sneak peak – to let you know I haven’t become a slacker.

Now where were we – oh, the Mudroom.

Here we are ready for the new counters. Everything is finally in place. Last time that sink base comes out.

Here’s the start of the counter install. I chose a white cashmere granite. It picks up the tones in the floor and works well with the wall colors. The wood supports for the counters are screwed to the studs behind and on the sides of the appliances. I used a laser level to get a good straight line for the supports.

Here are the workers from Cutting Edge Granite. Gerald Embry over there is great to work with. These guys fabricated the sink cut out twice. I was not aware that undermount sinks usually leave the lip of the sink exposed under the counter. I didn’t like this, and they cut another smaller opening for the sink for no additional charge.

Here the counters are in place. The sink base front is painted ceiling white – it looks a little peach against the bright white appliances. I’ll paint it white when I finish the doors.

Here’s the Delta Leyland Faucet added. I wanted to drop the sink top down to a normal level of 36″, as the tops of the washer and dryer are 40″ from the floor. This was just too tall for my wife to use and I didn’t want to have to integrate a step drawer in the bottom of the sink cabinet.

Here’s a close up of the sink, faucet, soap dispenser and fiber optic garbage disposal switch. I went with the fiber optic switch because of the simple interface and the fact that one touch lets the disposer run for twenty seconds and then automatically shuts off.

This is a  Kraus 23″ Sink This is a 16 gauge stainless steel sink. Remember the larger the number the thinner the metal, so many sinks are now made 20 gauge, so this dude is very, very sturdy. It’s 10″ deep, so it has some room. I didn’t go with a really deep laundry sink because I think my wife will use this to clean garden vegetables more than she will use it for laundry. Using the 10″ sink allowed me to add the garbage disposal, so when she cuts roots and pre-preps the vegetables the disposal will come in handy.

OK – we’ll leave this mudroom for awhile. We’ll revisit when I have time to make the doors for the upper and sink cabinets.

But we still have that sunroom foundation drama to cover – so that’s up next.Then there’s building the sunroom – adding 250 pound windows, a interior stair tear out and rebuild. A master bath, closet, and bedroom renovation. A full exterior renovation including that limestone previously mentioned.And some other stuff.

Gee, I hope all of you are still alive by the time I finish these posts.

Stay tuned…

 

Advertisements